Hydraulic Spray Foam Machine

Industry Best in Class Spray Foam Proportioner

Ready to Ship:

• Courier delivery system proportioning meter
  Patented design, only unit in the industry with divorced, separate, adjustable ratio hydraulic pumps.
• 50 lbs a minute
• Only hydraulic unit in the industry to be able to run off a portable
• 17,500 watt generac generator.
• Summer and winter preheaters out perform heaters 4 times their size.
• Patented helix ribbon twist heaters
• 3000+ psi
• Portable on wheels or modular wall mountable components.
• B side pump may be used as airless paint sprayer for elastomeric coatings.

Patented Divorced “Driver Pump Technology” in an advanced meter (or proportioner).

This modular technology will be the most contractor-preferred equipment for the following reasons:

• There are only two pressure pumps at the drums to feed the components to the gun, NO TRANSFER PUMPS NEEDED.
• B side pump may be used as airless paint sprayer for elastomeric coatings.
• There is no extra maintenance because there is no material supply package, and no transfer pumps. This saves $3 – 4k in equipment costs.
• You do not need a large compressor, refrigerated air drier, drum pumps, air lines and hardware.
• The meter has dual cycle counters at each pump to monitor the volume of material as it comes out of each drum.
• A special ball check system assures component flow. There is no pulsation at the gun
• The meter or proportioner operates on ratio more often than most other equipment because of the monitoring setup.
• The pumps are hydraulic reciprocating pumps with a 4” stroke supplying 2.5 gpm each with a combined 5 gpm (50 lbs a minute) output at up to 3500 psi.
• This modular meter component technology is portable and easy to maneuver into any area.
• The meter is easy to operate and maintain with no complicated electronics; it is simple and user friendly for the contractor.
• The equipment is designed with less flow restriction and fewer pressure drops or losses than other meter setups, leading to higher pressure throughout!
• Parts are readily available and rebuilding a pump is a snap, this saves thousands in maintenance and down time.
• This equipment is priced thousands of dollars below any comparable equipment.
• There is an optional hydraulic drum mixer for the coatings industry that runs off the same power pack.
• You can easily mount any of the modular components remotely in your rig, or you can wall mount the pumps.

Quality Components and Parts Used in Manufacturing:

• Eaton
  
• Idec
  
• Watlow
  
• Carlo Gavassi
  
• Baldor
  
• Metris
  
• Titan Tool